How to Enable USB Debugging in Uniscope U910 Plus


On this page, you will learn to enable USB debugging in Uniscope U910 Plus. You will be able to start enabling USB debugging on your Uniscope U910 Plus by following the steps below. If you own any one of Uniscope devices and want to enable USB debugging on your Uniscope device, read the rest of article. You can also download Uniscope U910 Plus USB drivers to prevent unrecognized USB connections.

Steps to enable USB debugging in Uniscope U910 Plus

  1. Go to App drawer on your Uniscope U910 Plus
  2. On your phone, go to SettingsAbout Device/Phone
  3. You will have to look for Build Number of your Uniscope U910 Plus
  4. Just tap over build number section about 7 to 10 times
  5. After tapping over build number, your device will display popup message saying that "you are now a developer"
  6. This will simply, unlock Developer Options menu in your Uniscope U910 Plus Android device

Recommended Uniscope device tutorials (You should read)

You might want to know how to install Uniscope U910 Plus USB drivers to be able to establish fine connection between smartphone to PC for firmware flashing purpose. Do follow the given useful articles below:

Do comment below about Uniscope U910 Plus Android device if you have any problems while enabling USB debugging.

Related USB Debugging Tutorials for Android Smartphones



Last Updated on

Leave a Reply

Your email address will not be published. Required fields are marked *