How to Enable USB Debugging in 360 Q5

Whether you're rooting 360 Q5, flashing an Image, installing firmware, or custom ROMS, enabling USB Debugging is a crucial step for 360 Q5. What is USB Debugging? It's simply a way for your device to use Android SDK over USB connection.

USB Debugging is especially appealing to developers as it allows them to run commands, transfer files to and from PC and do other critical tasks. Enabling USB Debugging on 360 Q5 is a piece of cake, it's neatly tucked away under Android's Developer Options menu.

On this page, you will learn to enable USB debugging in 360 Q5. You will be able to start enabling USB debugging on your 360 Q5 by following the steps below. If you own any one of devices and want to enable USB debugging on your device, read the rest of article. You can also download 360 Q5 USB drivers to prevent unrecognized USB connections.

Steps to enable USB debugging in 360 Q5

  1. Go to App drawer on your 360 Q5
  2. On your phone, go to SettingsAbout Device/Phone
  3. You will have to look for Build Number of your 360 Q5
  4. Just tap over build number section about 7 to 10 times
  5. After tapping over build number, your device will display popup message saying that "you are now a developer"
  6. This will simply unlock Developer Options menu in your 360 Q5 Android device
  7. Go back and now access the Developer options menu, check ‘USB debugging’ and click OK on the prompt.

Instructions for Android 2.3 or earlier

Enabling USB Debugging for a device running Android 2.3 or earlier is a different story. Here are step-by-step instructions for that:

  1. Go to Settings menu on 360 Q5
  2. Scroll down and tap on Applictions or Apps or App Manager
  3. Scroll down until you find the Development
  4. Tap on this and check 'enable USB debugging'
Do comment below about 360 Q5 Android device if you have any problems while enabling USB debugging.

Leave a Reply

Your email address will not be published.